Tonight
turned out to be one of those times you look back on it and think
"that's IT… that's all I got done!"… Oh well,
something is better than nothing!
|
(17-4 step 1):
On the underside of each leading edge skin there is a hole that
must be enlarged for a tie-down ring. You simply open up the hole
gradually with a step drill. I've found I get better results if I
step the hole up to about 1/4" first with drill bits before using the
step drill. Since I'm doing both leading edges at the same time,
I could drill both holes, change bits, drill both holes again, etc,
etc...
|
(17-3 step 1):
This is what took longer than it should've… the wing kit
has been sitting for almost a year, and the vinyl seemed like it didn't
want to come off. I got to do this solo this time, and with the
curved skins it was a nuisance… REAL productive work here!
|
