(Duckworks HID Landing Lights):
Ok, back to fitting the lense retaining brackets. I want to
at least get the upper ones fitted tonight. First thing is to
mark a line 0.3" from the upper edge of the opening in the wing.
Then the larger upper piece gets centered over the opening and clamped
in place on this line. I match drilled the two center holes to
the wing skin, and then clecoed the thicker, but smaller piece in its
place on top of the larger one. I then match drilled all the
holes into the skin. This stackup you see will be attached
exactly as you see it, but inside the skin. This will put the
smaller piece flush against the inside of the skin, and the larger one
will form a slot that the lense will fit under (between it and the
skin... if that makes any sense)
|
