(9-18 step 3):
Alright… time to finish drilling this trim tab
hinge. This hinge is where the trim tabs attach to the
elevators. In order to hopefully get this thing as straight as
possible and prevent the pin from binding when the hinge is swung up
and down I would drill a hole mid way between clecoes. So now
that the end and middle holes are done, the next one I did was mid-way
between the middle cleco and one of the end clecoes. I just kept
splitting the difference like this clecoing each hole as I went until
all the holes were done. The hinge swings freely!
|
