(9-18 steps 1-3):
Just poked my head in the garage to say I did something
today. I cut the two trim tab hinges to length and then deburred
the edges. After that I marked off and drilled the end holes that
are used to locate them on the rear of the elevator. This hole
was then used to cleco the hinge to the rear of the stabilizer. I
then aligned the opposite end in about the right place and used the
existing hole in the skin/spar to match drill a hole in the
hinge. This hole got clecoed and then I did the same thing for a
hole about in the middle of the hinge. As much as I want to
finish this right now I need to go...
|
