(7-10 step 5):
Didn't do a whole lot tonight... Wanted to at least get something
done so I riveted the rudder skins to the spar. Basically clecoed
every other hole, inserted a rivet in the open holes and went down the
line with the squeezer. Once those were set, I would pull a cleco
out, put a rivet in, squeeze, and repeat... This proved to be a time
killer! I got a bit smarter (only a bit though) on the opposite
side... after the first set of rivets I did the no-brainer and
pulled out all the clecoes at the same time, inserted all the rivets,
and went down the line squeezing... duh!
|
