(7-6 step 10): After
putting a bunch of scratches in the skins with the file yesterday, I
decided to try a different technique tonight... I took the countersink
bit and put it in our smaller drill that's not quite as fast, and
doesn't have nearly the torque. I had thought about doing this
earlier, but was a little worried about the potential to take off too
much material. How will I ever know unless I try it right!
I'm glad I did... this is the quickest method I've found so far!
|
Continuing on with deburring, Angela decided to give the countersink bit in the drill a try... she liked it too! |
(7-6 step
13): Nothing special here, just scuffing up the inside of the rudder
skins in preparation for priming. This took a little longer than it should have
because I had to remove those scratches I put in them last night. I think I'll
just clean them up a bit and put off the dimpling until tomorrow
night...
 |
| Home | Log By Date | <<Prev | Next>> |