I've
been looking forward to getting home to work on this all day! Ok,
first step, mark the Empennage fairing screw holes... done! Next
step, disassemble the skin & skeleton... done! Then I busted
out the soldering iron and cut the "requisite" RV rivet stripes in the
blue nylon film protecting the exterior of the skin. After that I
get to do the fun stuff... debur... and debur...
|
and
debur... and debur... wait a minute... what was it I was looking
forward to again??? Ahh yes... the sooner I get done with this,
the sooner I'll be priming and riveting this weekend!!
|
While
I "slaved" away with the deburring duties, Angela really got in to her
rudder project! I really expected her to jump back on the web
site, but instead she beat me to the garage tonight! I love a
motivated woman! Here she's working on Section 7, page 2, step 3,
separating the R-1010 shear clips for the rudder. I believe her
comment was "I want to give you some more parts to prime this weekend"
|
Cruising right through the shear clips, Angela jumped right into Section 7, page 3, the rudder stiffeners.
|
Angela
continued cutting & deburring stiffeners until I finished deburring
the skin. There are still a few more to do, but we're making some
good progress. Can't wait to continue tomorrow...
|
